Morimoto Retrofit Adaptor Plates

Status
Not open for further replies.
ok, i just started on a new batch, i should have aroudn 25 sets ready to go in around 3 weeks. If you want to reserve a set, you can leave a comment in here. Anyone who PM'd me, i will send you the link to here to reserve them. once they are finished i will send PM's out with my paypal.

Price is the same as before. and it is just the plates no hardware is included.

When you reserve please make it in a format like a group buy,

so if Pat wanted a set it would put

1. Oktain
2.

Then quote it, and put your name in, that way i can keep everyone in a good list and know how many i have.

Thanks.
 
About time fgt.

Words of advice though, make the four mounting holes oval and make the bowl cutout a few mm bigger for rotational correction.
 
BOO5TED said:
About time fgt.

Words of advice though, make the four mounting holes oval and make the bowl cutout a few mm bigger for rotational correction.
Click to expand...

i really didnt want to make anymore, i dont have the time, but obama butt raped me on taxes, and i need the money.
 
BOO5TED said:
About time fgt.

Words of advice though, make the four mounting holes oval and make the bowl cutout a few mm bigger for rotational correction.
Click to expand...

Why? My 5.0 plates are bang on.

Sent from my igloo using my SGS4 eh.
 
Oktain said:
Why? My 5.0 plates are bang on.

Sent from my igloo using my SGS4 eh.
Click to expand...

The 6.0 plates were a cunt hair off for me, could have just been the headlights though. :shrug: If he can do it, I'd rather see the ability to adjust them even if it's not needed.

I took my dremel and made the mounting holes oval and filed down the sides where the point is do I could adjust it. Made the space between the plate and bowl a little bigger but I just used more silicone to seal it up.
 
BOO5TED said:
The 6.0 plates were a cunt hair off for me, could have just been the headlights though. :shrug: If he can do it, I'd rather see the ability to adjust them even if it's not needed.

I took my dremel and made the mounting holes oval and filed down the sides where the point is do I could adjust it. Made the space between the plate and bowl a little bigger but I just used more silicone to seal it up.
Click to expand...

sounds hack imo
 
BILLY!!!! said:
saw it this morning on my drive to work seemed fine to me
Click to expand...

And there lies the problem. If you look at your truck and think it's ok but think me taking a mm off of a mounting plate to get a degree or two rotaion is hack I feel bad for ya son.
 
Pisses me off. Errone crying for plates, then when it's time to pony the fuck up. Nobody.
 
Status
Not open for further replies.
Top