Alecks' hopes and dreams thread.

Khaos said:
I'm keeping mine out of shitty weather so hopefully it lasts a little while.
Click to expand...

Gonna just throw mine on and see how it is. We don't really get shitty weather down here so I should be fine on that part. Gonna make sure the gaskets are good and everything gets sealed nicely.


Sent from my iPhone using Tapatalk
 
New bumper is on, 1.5" body installed (front bumper needs aligning but isn't off much), chrome handles will go in next Wednesday along with rear liners and exhaust probably Monday if my tip gets in.

Yay for mods! Lmao

437f7ded45527d0cab7082021251c652.jpg

9cc6017e7151f6ebec9c4cd8a78431ab.jpg



Sent from my iPhone using Tapatalk
 
Kind of a spur of the moment thing lol. Came out good though. Just need some POR15 for the frame now


Sent from my iPhone using Tapatalk
 
Chrome handles are installed. Exhaust going to be done Tuesday and getting the trans lines done at a shop to save me the headache. Not sure how I'm going to wire the e-cutout's wiring yet, I have yet to be able to find the firewall on this truck. Then again I haven't really looked hard enough. It has a 12v plug in (gross) but I'm probably gonna hard wire it to one of the 12v plugs and run the switch into my console or under my dash


Sent from my iPhone using Tapatalk
 
Firewall is by your feet. Trans lines are easy to do. Just need to carefully pry out the c-clips, they're a motherfucker sometimes
 
Yeah but I've looked up under my truck and have no clue how I'm going to get to where they connect to the trans


Sent from my iPhone using Tapatalk
 
static06 said:
Passenger side. I believe there's a shield with two 10mm bolts. I could be wrong but they should be behind that.
Click to expand...

They are but are in a super tight spot. Not sure what tool to use to get them off either.


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Top