Wanting to go 1" lower front and rear.
Current setup (07 NNBS 2wd):
DJM 2" lower arms
McGaughys 2" spindles
DJM rear flip
Should I go with Belltech or McGaughys 1" lowering coils? What do I do about the rear? I'm using factory hangers.
id go with belltech adjustable struts and shackles in rear
Belltech 4/7 with Airlift helpers Stock tires rub like a MF'er
HoR-HeY 81
Your truck looks like 5" in front compared to mine, I am 4" using belltech struts and spindles.
Wanting to go 1" lower front and rear.
Current setup (07 NNBS 2wd):
DJM 2" lower arms
McGaughys 2" spindles
DJM rear flip
Should I go with Belltech or McGaughys 1" lowering coils? What do I do about the rear? I'm using factory hangers.
Hmmm maybe cause I never measured, I have BT Adjust struts at 0, BT 2" Coils, and BT 2" Spindles
You got pics of yours?
HoR-HeY 81
Just cut some coil. No need to spend money for an extra inch. Unless you're one of them that thinks cutting coils is "hack"
The struts will give you the option to change from -2" to +2" in 1/2" increments. Can't lose! What if 1" isn't low enough or too low w coil?
A lot of work for nothing IMO
HoR-HeY 81
Ah, ok the coils must have something to do with it then. My struts are set @ 2" and I have 2" spindles, all belltech.
The yard makes it look like the front is higher, but it sits pretty level.
Originally Posted by QuicksilverZ71
My front sits 2" higher exactly than the rear. I have the mcgaughys flip in rear and the mcgaughys spindle along with a strut up front set to -2. Why is it not sitting level like all other 4/7 I see?[
I have the single 10mm ring on. The rear is a flip only.
So you have belltech struts or McG relocators?
Edit: My 4/7 never sat level either. I went up to 4/6 for level then down to 5/7