My 2014 LTZ Build Thread

Yep mine sit about 1/2 inch lower on drivers side after it all settled.

Sent from my SAMSUNG-SM-N910A using Tapatalk
 
Get a couple 400 pound chick's to ride in the passenger side for an our or two. It'll level out

Sent from my SM-G935V using Tapatalk
 
Yes I made a spacer to go between the strut and control arm

Sent from my SAMSUNG-SM-N910A using Tapatalk
 
I made them 1/4" thick so if I needed more or less I could stack them.
86901b4b9f54fb5088dac57bf67d8a40.jpg


Sent from my SAMSUNG-SM-N910A using Tapatalk
 
14 Silvy said:
I made them 1/4" thick so if I needed more or less I could stack them.
86901b4b9f54fb5088dac57bf67d8a40.jpg


Sent from my SAMSUNG-SM-N910A using Tapatalk
Click to expand...

Thanks a lot bud. How many did you end up using? I'm going to get a buddy of mine to fab me up something.


Sent from my iPhone using Tapatalk
 
I put one on drivers side then had some old struts out of my 07 and took the spring off and cut a 1/4 coil on pass side. I'm gonna put the McGaughy's struts on then I can fine tune it with them. I can send ya some spacers if ya need.

Sent from my SAMSUNG-SM-N910A using Tapatalk
 
14 Silvy said:
I put one on drivers side then had some old struts out of my 07 and took the spring off and cut a 1/4 coil on pass side. I'm gonna put the McGaughy's struts on then I can fine tune it with them. I can send ya some spacers if ya need.

Sent from my SAMSUNG-SM-N910A using Tapatalk
Click to expand...

I will see! I just want to get one 1/2" made and I think that will fix my problem


Sent from my iPhone using Tapatalk
 
Well y'all were right. Took fender measurements today. All fenders measure almost exactly 32" from ground to middle of fender on flat ground minus the driver side rear fender sits right at 31" when the tank is full. Truck is set at 4/7 with Belltech spindles/struts on the front and Belltech flip kit in rear with Belltech sp shocks. To fix my problem I plan on using shackles on the rear. I'm going to wait another week to see if the front settles anymore. I've only put about 250 miles on my truck since the drop has been installed. Going to remeasure again at 500 miles. But if it's already settle I plan on going another inch lower in the front with McGaughys drop strut spacers and setting rear shackles at 1" on driver side and 2" on passenger side. Think it will sit perfect after that. But I'm going to wait a couple weeks before I make any decisions


Sent from my iPhone using Tapatalk
 
61960e9abc690c12502803d3337ace00.jpg

e49be2c3ce9c0b3e7d0422e24c10689b.jpg

38421c258c0bd8d9106081f90b3cb606.jpg


Underbed Step c notch from The Setup is being installed.


Sent from my iPhone using Tapatalk
 
Last edited:
You must log in or register to reply here.
Top Bottom
Back