2piece driveshaft

2-pc driveshaft

I think I'll just do that then what size is ur driveshaft also drop and tire size


Sent from a secure terminal using the classified military network
 
Re: 2-pc driveshaft

Shaft is stock 4" and had it reduced an inch so its 3". I'm at 6/9 with 265/35r22

Sent from my DROID RAZR M using Tapatalk 2
 
2-pc driveshaft

How far is frame from ground? I'm trying to figure out how much I gotta shrink it then ill order one from MW


Sent from a secure terminal using the classified military network
 
Re: 2-pc driveshaft

usa7yna7.jpg


Sent from my DROID RAZR M using Tapatalk 2
 
BILLY!!!! said:
How much did that cost u? I'd rather have a smaller 1 piece than a pinion angle that's all over the place with a 2 piece


Sent from a secure terminal using the classified military network
Click to expand...

why would the pinion angle be all over the place?
 
Re: 2-pc driveshaft

I'm not clearing by much. Does anyone run a one piece being bagged?

Sent from my DROID RAZR M using Tapatalk 2
 
I got to imagine you'd have to notch the fuck out of shit to run a 1 piece bagged. Should be installing 2 piece in a few weeks. Will try to make clarified how to on infornation I've gathered and experience in install.
 
Re: 2-pc driveshaft

I dont see the point in narrowing the big aluminium one when you can get a 2piece and is exactly like stock except you move charcoal canister and weld crossmember in. And you can put the carrier bearing exactly where you want it before you weld then your done and can go as low as you want. And that pic makes yours not look 6/9 do you have pics of entire truck. I wish I had just went 2piece instead of notching everything but whatever its done now and will redo it when I swap to coilovers w/ 4-link....


Sent from my Samsung Galaxy SIII using Tapatalk 2
 
2-pc driveshaft

I haven't thought about it too hard but I think u get less pinion angle change with 1 piece


Sent from a secure terminal using the classified military network
 
2-pc driveshaft

Mine hates when I step on it at all, when I gun it around 30 it sounds like its hitting and grindingan gonna snap
 
450E67D3-C37E-4BAF-A306-A9B6089D771F-7166-000006E3F2CB50C2.jpg


For you guys wanting driveshafts just go to car-parts.com and enter the info like I did but change the year and zip code. Then on the next page select a extended cab 143.5" WB(wheel base) with a AT(auto transmission).
 
Last edited:
Re: 2-pc driveshaft

I remember your truck from gmfgts yours was 4wd correct and you planned to bodydrop?


Sent from my Samsung Galaxy SIII using Tapatalk 2
 
You must log in or register to reply here.
Top