TILLER

Well-Known Member
Aug 28, 2012
2,034
34
48
31
Hallsville Tx
Headers are on, they were a royal bitch to do by myself. Going to get the flex pipe thing cut off and weld a piece of pipe in there since I can't get it to seal up 100% and then tune tomorrow


Sent from my iPhone using Tapatalk
 

Oktain

Canuck Admin
Staff member
Feb 9, 2012
4,921
192
63
31
Sudbury, ON
I fucking HATE that flex pipe thing. I dicked around for 20 minutes with my catback trying to get it to seal, the only part that took longer was letting the exhaust cool down enough to not melt my Mechanix gloves lol. I'm sure I don't have a perfect seal, but I'll tackle that whenever I decide to go with LT's.
 

Frizzle53

Active Member
Sep 4, 2013
506
185
43
Flex pipe or the slip joint on the crossover? Slip joints never seal good. Get them to weld in a vband instead.
 

Gannon

That Guy
Jun 10, 2012
4,710
49
48
Logansport, Louisiana
Headers are on, they were a royal bitch to do by myself. Going to get the flex pipe thing cut off and weld a piece of pipe in there since I can't get it to seal up 100% and then cam and tune tomorrow


Sent from my iPhone using Tapatalk

Fixed


Sent from my SM-G900V using Tapatalk
 

TILLER

Well-Known Member
Aug 28, 2012
2,034
34
48
31
Hallsville Tx
I wonder what a header install on a 4x4 is like lol

The ones I did on my nnbs were equally a bitch.. but I had room to work when I pulled the wheel well liners unlike this one. The rear header bolt on the drivers side is going to suck when you do it


Sent from my iPhone using Tapatalk
 

Nasty

Active Member
Mar 11, 2015
346
105
43
Northern califas
I'm buying my 3/6 kit next week. I'm going to get a 255 55 20. I figure that's 1" taller than your tire but you are also 1" lower all around. You don't rub at all now do you?
 

TILLER

Well-Known Member
Aug 28, 2012
2,034
34
48
31
Hallsville Tx
I'm buying my 3/6 kit next week. I'm going to get a 255 55 20. I figure that's 1" taller than your tire but you are also 1" lower all around. You don't rub at all now do you?

You should be fine.


Sent from my iPhone using Tapatalk
 

TILLER

Well-Known Member
Aug 28, 2012
2,034
34
48
31
Hallsville Tx
What kit number? The ones on mcg site say will not fit steel control arms. I have steel arm and spindles

5f7ae4480999c4750497b8b9cb061621.png
the stamped steel or the cast steel?



Sent from my iPhone using Tapatalk