Got some sbc valve covers for the motor. Not really happy with the powder coat on them. Might end up having them redone once it’s all donegot me a 66 caddy
- Thread starter lowlife08
- Start date
Got some sbc valve covers for the motor. Not really happy with the powder coat on them. Might end up having them redone once it’s all done
I thought I read that you had to run disc in the front. This is good news as I thought I had to do it all at once. Thinking about it again you're running stock wheels which should have clued me that you're running stock brakes.
You might have the rims for disc brakes. I can’t remember for sure which year rims you gotta get to run them
Only them 15s so I don't think they will fit. I am fine with running the drum brakes with that front end for the time being. I have limited funds to throw at it at anytime so doing things in stages is alright with me.
I can't remember, did you have any issues with the tranny or driveshaft tunnel and being able to lay out before? I honestly have no idea if mine was modified but people ask me all the time so I assume that it must have been.
Ya the shop that did mine the 1st time did a little tunnel just under the back seat. It needed to be bigger tho if I was driving low you would hear the drive shaft hit some times.
Rustlab is putting the pans above the frame so I won’t ever have to worry about them hitting anymore either
The stock gas tank is still there now. I don’t think I have to change it But they haven’t got to that point yet so I’m not sure
But a guy I follow on Instagram who is getting a bad ass caddy built right now used this tank with a drop in fuel pump
http://www.tanksinc.com/index.cfm/p...ct_id=414/category_id=-1/mode=prod/prd414.htm
http://www.tanksinc.com/index.cfm/p...ct_id=414/category_id=-1/mode=prod/prd414.htm
