Dirty LBZ Pics

Wicked Mayhem

Wicked Mayhem

FUCK YOU
Mar 15, 2012
474
0
0
Did a little more to the truck. Before i was cranked with cognito uppers, stock rear... Now i de cranked a little bit, and added a 4" spindle and 3" tapered block. Rides alot better now. I also put a 2" spacer on the carrier bearing because it had a vibration taking off and it made a growling noise at 65ish. Need new tie rods.. Not sure what i wanna go with for them.

Dirty pics, but looks half assed ok in pics, minus suspension.


1390671703.jpg

1390671684.jpg

1390671681.jpg

1390671676.jpg

1390671687.jpg
 
Kryptonite tie rods from DMAXstore.com seem pretty nice. From what I've read they hold up well for sled pulling, etc.

My Cognito's are also pretty beefy

If you're looking for a better deal check these out:

FS: Kryptonite tie rods - Duramax Diesels Forum

Offer him $250 or so shipped :corny:

Truck looks amazing BTW Never used to be a fan of those wheels but you converted me.
 
Last edited:
Thanks for all the good words. Im undecided on what tie rods I want. I dont need i need super bad ass ones since its not 4WD right? I just know the one time i went to hop up on a curb to get around someone my alignment was off after that. Stock tie rods look so dinky. I could make a heim setup easy enough, Just need to do it lol.

Fender measurements

Front: 45-1/2"
Rear 44-3/4"
 
It looked sick leveled, but this is perfection. If you candied your tails and cleared your heads, it would really set it off :imo:
 
It looks great man!!!! I really love how 2wd's look with lift spindles on. So much ground clearance lol


Sent from Tapashit
 
Cornell said:
Kryptonite tie rods from DMAXstore.com seem pretty nice. From what I've read they hold up well for sled pulling, etc.

My Cognito's are also pretty beefy

If you're looking for a better deal check these out:

FS: Kryptonite tie rods - Duramax Diesels Forum

Offer him $250 or so shipped :corny:

Truck looks amazing BTW Never used to be a fan of those wheels but you converted me.
Click to expand...

I hear that kit has binding issues, did they ever work those out?


James Pate said:
I would look into the new heim tie rods that cognito came out with
Click to expand...


Not sure where he is from but DNW Heim joints in cold/snow/salted areas. I was constantly under the truck spraying the pitman and idler arm supports with grease.
 
You must log in or register to reply here.
Top Bottom
Back