Denali console makeover

:turborofl:

I got my 3M stuff at our equivalent to Auto Zone. Made debadging so much easier lol. The hardest part was going through 2 things of dental floss to cut through the tape and peel the badges lol. After that it was spray, let sit, spray, let sit, let dry a little, then peel.
 
Heat it up with heat gun/hair dryer and apply that adhesive remover and get after it with a paint scraper


Sent from my iPhone using Tapatalk
 
:lol: good shit, thx. 3m is en route, I'll use my mom's hair dryer, and will stop by the Depot for plastic scrapper in a few days.

So no I Havnt touched anything yet. Can't till Sunday
 
Got the carpet off. Tried to scrape and wire brush as much leftover fuzz and glue off, ended with this
7791e1feabe5cee606dacdd6f4b4ea51.jpg


cf4361c0dfc86981b965515fd0b1a50e.jpg


Overtop
76b0460b917fe93b7529ca93cf1a5024.jpg


Peeled carpet in one piece so I'll use these as tracers for suede
b5ad6da6630f8bb2d2c58ea1a64e210f.jpg


Dat suede bed doe
5845493074a41478cd500588532f3a98.jpg


Trace of bass. Totally just winging it on how to do all this lul. Carpet was exact fit to console, but I left about 1/4ć extra around for shits
433d4ffb50d18e6e11c82b230770a038.jpg


1db64c6036378a8836b1dd6c8b124ba0.jpg
 
Last edited:
Well the trace turned out like shit. It'll work, but shit. I cut the next one but glued it first, came out so much better. Just did a rough outline, covered all then razored and tucked edges
1d7ca32558c72fcbcc69085e148e3f94.jpg


Don't have shit side pics yet
 
Well the carpet wasn't tucked, just cut off at all the ends. So I guess I planned on that and 1/4-1/2" wasn't enough cause I still fucked the angel of cut.

I'm not gonna layer a new one in top. It should look fine once installed. Messy areas will be covered up
 
You must log in or register to reply here.
Top Bottom
Back