How are you guys wiring your fog lights on your nbs Silverados?

Discussion in 'Exterior' started by Jvega01, May 31, 2019.

  1. Jvega01

    Jvega01 New Member

    I’ve been trying to install fog lights on my 2000 silverado, it did not come with the factory ones and I have a z71 valance with fogs, how would you guys recommend to wire them? Any kits you guys recommend? [​IMG]

    Sent from my iPhone using Tapatalk
  2. BigBoi

    BigBoi Well-Known Member

    I had a ‘15 Colorado that didn’t come with fogs. Added factory ones later and just got a stand-alone harness and wired a little rocker switch beside my headlight switch. Was super simple and a hellllllllll of a lot cheaper than trying to wire them in the factory way.

    Something like this.

    And then just wire the little pig tails to your lights. Run the hot wire to the battery. Done. Super simple, clean look.

    Sent from my iPhone using Tapatalk
    dszx13 likes this.
  3. Dubyagee

    Dubyagee Dork

    I ran a relay to the fogs and had a switch but later tied the relay to the parking light circuit.
  4. Oktain

    Oktain Canuck Admin Staff Member

    Moved to the proper section of the forum. How-To section is only for posting instructions for modifications/repairs
  5. HackMcMaster

    HackMcMaster Active Member

    You can get the pin info and everything from AllDataDIY if you sign up for an account
  6. Tylers88

    Tylers88 3 GM's and a Jeep

    AllData is the shit, half the time I used that over GMs stuff at the dealership
  7. HackMcMaster

    HackMcMaster Active Member

    Not the easiest to navigate though

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice