Search results

After they truck dying in my driveway last night and not moving it, I just got in it and it drove great. I punched from a dead stop and rpms went up to almost 5500 before changing to 2nd gear and then to almost 4500 before changing to 3rd gear. So whatever the issue i think temperature is...

This started a little while ago. The issue starts when I'm going down the hwy at about 65-70 and about 2000 rpm. When I punch it the truck starts to bog down, like it's not getting enough fuel. Eventually it gets worse to the point the truck dies. Sometimes the truck will start but when I press...

Thnanks Ginger. Its not the gas, these sensors have been bad for a while. Let me ask you, you mentioned silicone. where do I put the silicone. I found one bulletin showing. It said around the outer edge of the ridge of the knock sensor. Is that were you out it? Thanks R.

I ran my AutoCal the other day to look up my error codes and the AC came up with 3 of them. P0135, Upstream O2 Sensor (left cylinder bank) heater performance P0327 Knock Sensor signal freq outside normal range P0332 Knock Sensor signal freq outside normal range According to the Haynes manual...

Thank you for the heads up. Oktain just posted so I'll PM him. again thanks

My Flowmaster 50 sound on 02 Tahoe Not sure if this goes here but I'll try. I got a chance to install my Flowmaster 50 on my 02 Tahoe today. For those interested here are a couple of sound files. Flowmaster 1 is sitting in my driveway just starting the truck up. The second is driving around...

I got an 02 Tahoe and I want to put rims and tires on it, but I'm looking for somewhat of a specific look. The rims I want are the American Racing Dagger (all silver). Now here's where I need your help. I don't know if I should get 20s or 22s? As for tires, I don't want low profile tires or...

Hey guys, I'm planning on changing my radiator fluid as soon as my DEI Radiator Relief gets here. I spoke to one of their reps and he suggested I also add a water pump lubricant, so I'm wondering what product you guys recommend for that? Thanks in advance for any feedback. R.