Search results

  1. Blue97

    *99-07c 2WD Drop Parts and Recommendations*

    I'm using BT drop spindles and stock shocks are fine with them , but if I add the 1" drop coils that's why I was asking
  2. Blue97

    *99-07c 2WD Drop Parts and Recommendations*

    Bringing this back from the dead..... I have a 03 silverado rcsb doing a 2/4 drop... spindles , shackles and hangers.... If i use the belltech 4302 1" drop coil would I also need a drop shock ? Asking because I just put on new bilsteins Thanks
  3. Blue97

    Borla touring cat back ....Any good?

    Nevermind... Nothing to see here
  4. Blue97

    MCGAUGHYS 16 + spindles

    Yes and you will be fine with your 20's Sold!!
  5. Blue97

    MCGAUGHYS 16 + spindles

    I have it packed in a LARGE flate rate box. If I remember it's like $18
  6. Blue97

    MCGAUGHYS 16 + spindles

    And you pay for the ride ?
  7. Blue97

    MCGAUGHYS 16 + spindles

    99-06 Sorry about that...
  8. Blue97

    Static NBS Thread 99-07c

    Good to know, I've been unsure of tire size and figured I'd just stick with the 275/45/20. But I'm only doing 2/4...
  9. Blue97

    Static NBS Thread 99-07c

    I've had a set of those wheels in my garage for months waiting to go on my 03 rcsb and I could never find a rcsb with them.. they look good. your truck is clean and very nice, cant wait to get mine down...
  10. Blue97

    MCGAUGHYS 16 + spindles

    MCGAUGHYS 2000C spindles new new new.....came in a 2/4 kit and not going to use them, all hardware included..... $200
  11. Blue97

    mcguaphys 16 + spindles

    Did you torque the stud to 75ftlbs before installing the hub....
  12. Blue97

    mcguaphys 16 + spindles

    I bought a Mcgauphys 2/4 drop and it has the 16+ spindles months ago and I'm thinking of installing it. But I have a few ?'s I was reading the instructions and it says to torque the stud ( that holds the hub/bearing on ) to 75ftlbs........ if you know or have these I'm sure you known what...
  13. Blue97

    Grinding McGaughy 16" spindles and notching control arm for lower bj

    Nice/\ I should go to local post office and grab a box. Thanks
  14. Blue97

    Grinding McGaughy 16" spindles and notching control arm for lower bj

    Yes that's what I will do Craigslist is probably the best due to shipping. Going to order the Belltechs from Summit. I want it all here so when I'm on vacation I can do it... sorry , didn't mean to drag out this thread l but I really do appreciate everyone's input.. Thanks...
  15. Blue97

    Grinding McGaughy 16" spindles and notching control arm for lower bj

    From what i read over on gmfs, the belltech spindle won't lose turning radius... I've already replaced my upper and lower control arms and really don't want to drill out the rivets on the b/j Wish I researched this a Lil better before buying the 2/4 drop kit.. Thanks
  16. Blue97

    Grinding McGaughy 16" spindles and notching control arm for lower bj

    One more ?, I've got the 16+ kit . So If I get the 17+ spindles I don't have to move the balljoints...