RCSB Derpamax Build

I took your advice and shaved it. Going to do the pocket too.

su4are9y.jpg


yga6are9.jpg
 
It will look so much better. You going to add a switch for something on the plate or did you just like the shaved look?
 
Tukn4s said:
It will look so much better. You going to add a switch for something on the plate or did you just like the shaved look?
Click to expand...

I might put my EFILive dsp5 switch there and 3 others for light bars and if I ever put a backup camera in a switch to turn it on manually. Plus it looks good and that pocket that's there is useless. Thanks for the idea!
 
Primed ready for paint.

ety5uzyt.jpg


7yneju5y.jpg


Went to hook my radio up and started running wires for my amps and speakers. Radio won't turn on and now my shifter light indicator isn't illuminated. Frickin goofy considering all I ran was ground power and ACC wires to the radio and somewhere along there something happened. Checked all my fuses and nothing was missing. Checked to see if I fried the internal ground on my ecm too and that's fine.
 
why must everything you do be so :boobs: interior is coming along nicely will be sweet show truck when your done ...
any luck finding a fleet side ?
 
Speakers came today.

rehyty7u.jpg


SA 10 next to an SA 12 and two PPI flat piston 10's.

Sundown components as well.

Had to drive the CC today since the RC is out of commission.

5yme9ajy.jpg
 
Dat dash doe.

Might have to do a similar setup eventually. But Android muahahaha

Sent from my igloo using my SGS4 eh.
 
...well this turned out better then expected.

and that expection was pretty high considering its Corny over thur
 
Figured out why the truck wouldn't crank. Bad starter relay and ignition fuse. I visually checked it but finally pulled it and it was junk.

I hooked up my sa10 and put it in the box. Sounds better than the sa12 in the shitty temp box I made for that.
 
You must log in or register to reply here.
Top