Recent content by Tech1451

Thanks. I've pretty much narrowed it down to the 34170 kit if they've corrected the issue. Hopefully I won't have to shorten the drive shaft and the alignment come in ok. I was going to start at 3/5" and hope that clears the tires. Then when it comes time for tires I'll probably go lower. If...

DemoN said above the McGughys had corrected. Is that not the case? Ordered their kit would be the easiest but if I need to piece together a kit I can.

Do you know if the 34170 Mcgaughys kit requires the drive a haft to be shortened? I've seen a few complaints about vibration. Set at 3/5" do you know if the stock tires (275/55R20) will clear without rubbing?

Nope. Has to be in VIS that it's been performed.

This. Pull the connector and ohm out the seat element. Then sit and move around. The measurement should change very little. If it moves all over the place it's bad. Seat heaters can be a PITA to diagnose. Had one fight me for an entire day once. The problem is usually in the heater elements...

Fred, I found your thread while looking at drop kits. PM'd you some questions. If you ever get up to Cypress, hit me up.

Looking at the McGughys 34170 kit that is adjustable. I will most likely start off at 3/5" and then 4/6" or 7" when it comes time for tires. Hopefully that stock 275/55R20's don.t rub too bad at 3/5". Your truck looks badass and is the direction I will be going with mine. Those wheels are...

Found the site while look at different drop kits for the truck. Just got a 2014 Sierra SCSB 5.3. Just dropping in to say hello.

Truck looks sweet. I was looking at different drop kits and found a thread were you talked about the McGaughys #34170 kit. Did you do the install yourself? If so, did it seem like a good quality kit? DO you have stock sized wheel and tires (275/55R20)? Any rubbing issues? Any vibration...